Features:
Firmware Version: 1.96
Languages: English
VAGCOM 16.8 inside IC:Original Chip ATMEL ATMEGA162 + 16V8B + FTDI FT232RL
System requirement: Windows XP, Vista, 7, 8, and 10(32-bit and 64-bit)
(It does not support Windows 95, 98, ME, and NT4 operating system)
(It does not support Windows 95, 98, ME, and NT4 operating system)
Vagcom 16.8.0 New Features:
Auto Scan 1001.01
1. Control module unit information,
2. Read fault codes 004.01
3. Output test 005
Selective output test 005
4. Basic settings 006
5. Clear DTCs 004.10
6. Close control module 022
7. Pairs of coding control module (brush hidden) 007 (service 1A)
008 (Service 22) From the station control module 007 coding (service 1A)
008 (Service 22) Read measured value block 08 010.02 (KWP1281)
8. Advanced measurement reading
9. channel read 010.01
10. matching 012 014 (long)
11. Log (Known under KWP-2000 * Coding II) 015.01
12. View readiness 020.01 Guided ready state settings
13. security access 015.02
14. All supported DTCs
15. Common OBD-II function
16. Fault environmental data
17. Dual K-Line Support 7-PIN code 020.07
18. Upgrade to the latest fault code library
19. Direct CAN line diagnosis (Need to support diagnostic cables CAN line diagnosis)
20. Modes of transport 1001.03 (on)
1001.04 (off) (Need to support diagnostic cables CAN line diagnosis)
21. Advanced measurement block
22. Support for dual engine control module
VCDS 16.8.1 EU version only can use original software,earlier version of the original software also can be used.we also have other VAG cable like vag 11.11.3,vag 12.12...
more information welcome contact with us:
Skype: yinmilo
Whatsapp:+86-13537734676
Email: obd2cartool@hotmail.com
Live Support: www.obd2cartool.com
Tech support: obd2cartool@outlook.com
If you are wholesaler or reseller, pls send email to obd2cartool@yahoo.com, we will give you best discount for long-term cooperate.
No comments:
Post a Comment